2 to 6 Layers up to 100 sq. inches in area
Standard Technology only.
No gold, no step and repeat.
Gerber RS-274X or ODB++ file needed.
Down to 0.004" min trace/space allowed (4 mils)
Max dimension 15.9"
Min. dimension 0.5"
Max Area of PCB: 100 Sq. Inches
Note: We may increase solder mask clearances to be 2 mils (0.002") over the feature size on each side.
Hot Air Solder Leveling (HASL)Lead-Free HASL (RoHS Compliant)
This applies if you have SMT devices on your board.
To create proper soldermask dams, we require a minimum 8 mils (0.008") spacing between adjacent SMT pads. Kindly ensure your design has that minimum spacing between SMT pads. If such spacing is not possible, we may gang-relieve the soldermask around those pads.
No minimum quantity, even 1 PCB can be ordered.
0.005" minimum width of annular ring. (In other words, pad diameter has to be 0.010" more than the hole diameter). [ view details
No gold allowed on the board
The distance from the edge of the board to any copper feature must be minimum 10 mils (0.01")
Do not use this online special if your job requires I.T.A.R. compliance.
Instead, send file to firstname.lastname@example.org
for a custom quote.
Credit Card ONLY
Outer Layers: 1 oz. Finished
We start with 0.5 oz. Copper foil and after plating we end up with 1oz Finished Copper on outer layers.
Inner Layers: 0.5 oz.
Min. 0.008 inches (8 mils) Finished Hole allowed.
Max 0.246 inches (246 mils) Finished Hole.
Max 0.250 inches (250 mils) Non-Plated Hole.
An individual board can be up to 100 square inches area.
White, Component side (top side) only. Extra for silkscreen on both sides.
Note that all legend should be at least 3 mils (0.003") away from copper features.
Legend closer than that may be clipped by our program.
Routing & Outlines
Individual Routing expected. No Arrays.
Board outline can have up to 8 Notches. Each notch must be at least 100 mils wide. Board can have rounded corners, but radius must be at least 31 mils (0.031"). Note that at least one corner of board must be 90 degrees. Board can have chamfered corners (45 degree chamfers).See example of notches and chamfers
Requirements for Outlines and Filled Areas
Slots & Cutouts
Plated and non-plated slots are allowed.
Non-Plated cutouts are allowed.Plated cutouts are NOT allowed
Maximum 10 slots/cutouts per board.
Minimum width for slot/cutout is 24 mils.See example of cutouts and slots
Your boards should AVERAGE no more than 75 holes per square inch.
(AVERAGE = Total holes on one board/Area of one board)
No Step and Repeat, no Scoring, and no Route and Retain allowed.We typically expect your Gerber files to have a SINGLE IMAGE of a SINGLE PCB. If you have MULTIPLE PARTS
on one image, extra charges may apply. Contact email@example.com
Edge of drill hole to nearest adjacent copper feature must be at least 10 mils (0.010").